Ask Me Help Desk

Ask Me Help Desk (https://www.askmehelpdesk.com/forum.php)
-   Appliances (https://www.askmehelpdesk.com/forumdisplay.php?f=157)
-   -   Where does the ice maker hose lead (https://www.askmehelpdesk.com/showthread.php?t=371377)

  • Jul 2, 2009, 12:58 PM
    rayne3rr0r
    Where does the ice maker hose lead
    Hello, I have a problem I turned on the water line to my frig and now there is water spraying out of the front (bottom). Out of a hose that looked like it was cut or blown, where does this hose lead to so I can repair it? It's a General Electric white side by side.
  • Jul 2, 2009, 01:16 PM
    hkstroud

    First edit your post and put in a few capital letters and periods so we know where a sentence begins and ends. Second remove the toe kick under the door and tell whether the bursted hose is before or after the solenoid water valve.
  • Jul 2, 2009, 01:26 PM
    afaroo

    Do as Harold instructed you, I am sure you will find the hose either blown or cut close to solenoid, good luck.

    John
  • Jul 2, 2009, 02:34 PM
    rayne3rr0r

    What does the solenoid water valve look like?

    Eddie
  • Jul 2, 2009, 03:01 PM
    afaroo

    Open the link below and you will see all deferent solenoids, Thanks.

    John

    refrigerator solenoid Refrigerator and Freezer Accessories - Compare Prices and Buy refrigerator solenoid Refrigerator and Freezer Accessories at Shopping.com
  • Jul 2, 2009, 04:57 PM
    rayne3rr0r
    OK that part is right at the spot where the water hook up is and its leaking further up than that
  • Jul 2, 2009, 05:16 PM
    hkstroud

    So the bursted hose is between the water solenoid valve and the dispenser. Correct?
  • Jul 2, 2009, 06:07 PM
    rayne3rr0r
    Yes think so but I am not sure where it would connect to
  • Jul 2, 2009, 09:39 PM
    hkstroud

    There should be one line coming into the solenoid valve, one line going out to the ice maker and one line going to the water dispenser. If you turned the water on at the stop valve and water immediately started coming out, the break should be between the stop valve and the solenoid valve.

  • All times are GMT -7. The time now is 10:22 AM.