Greetings,
My home is 3-wire. I bought a Hunter ceiling fan (model 23811). The fan came with a remote assy. That I do NOT want to use...

The fan has standard 3-wire connections (black, white, blk&white strip, ground). The remote receiver home-side wiring looks to be for 2-wire (blk and white). I wired the fan directly to the home (blk-to-blk, wht-to-wht, blk/wht-to-red). The lights on the fan work, but the fan does not turn. I assumed that there would be a default fan-speed once power was applied, but that does not seem to be the case.

Do I simply need to replace the on/off wall-switch with a ceiling fan control, or does a "remote" fan have to use the remote?

Thank you,
Brian

First thing I always check with this case, is check to see if it all works with the switch on, pull the chain make sure it all works.

If it still doesn't work, does the remote receiver have a separate mottor or is it already inside the fan?

If all this check out OK, then you may want to check your switches wiring.

I don't think the switch itself would be bad, but it is a possibility.

Wow... fast response! Thank you!

The fan itself does not have a pull-chain. All controls are through the remote.

The remote receiver is a separate assy. sitting between the fan wiring and the home wiring. The remote assy. Has blk, red, and white wires that the fan connects to, with blk and white wires going to the home.

The switch worked fine with the previous fan (non-remote, 3-wire).

OK It sounds like the fan can only be operated with the remote >.<

Sometimes they come as either/or types, but yours sounds like it has to be used with the remote.

I think the previous poster is correct. If the remote was included with the fan, and the fan does not have a separate (pullchain) control, you will have to use it to control the fan. You can try contacting Hunter to see if they have any ideas.

Let me ask you this: Where is the reverse function, on the fan body or on the remote?

The reverse switch is on the fan body.

I don't know why it Wouldn't work, if you wired it directly, but:

If it's designed to be used with a remote receiver, and you are using it without the remote receiver, and it's not working.. . 2+2 USUALLY equals 4.

Try it WITH the receiver. If it works then, well.. .

Thank you for the response.
2+2 does in fact equal 4. It works fine with the receiver and remote...

As the original question explicitly stated, I was inquiring as to the possibility of hard-wiring a "remote" fan to a 3-wire wall-plate, thereby circumventing the remote assy.

I guess it can't be done without rewiring the internal circuitry of the fan itself.

In this case, based on the wiring you describe, I don't understand WHY the fan does not work when 120vAC is applied across the black/blue and white wires. But apparently it does not, and seeing as it is not right in front of me to look at, it's not surprising I'd miss something.