:confused:My Amana gas dryer ALG 443 RAW works fine in all modes but Timer does not move & does not stop in Auto/ Permanent press mode. Dryer runs for ever.But it stops in the timed dry. The timer is fairly new. I checked the cycling thermostat's 3 terminals for continuity as well as Bias heater for continuity and they read 00.5 ohm. I ran the dryer after removing the lint collector attached to the blower housing but didn't yield any result. Appreciate your solution for the problem. I

This might help

http://www.servicematters.com/maytag...s/16021967.pdf

AND this

http://www.servicematters.com/maytag...S3200007R0.pdf

During research I red that dryers are sensitive to airflow. I cleaned the vent and took out good amount of trash. Now the dryer performs OK in the auto mode.

HVAC1000,
Thank you very much for your help.

Good deal now you will have to do the laundry. LOL