First time user. When I restart my computer message box pops up that says "RunDLL error". The message inside the box says: "Error loading: C:\Program Files\Commom files\ParetalLogic\UUS2\UU5dll". Underneath that it says "The Specified Module Could not be found.
It doesn't appear to be hurting anything but is somewhat of a nuisance.
Any help as to how to get rid of this and it's significance, if any, would be appreciated.
Thanks
Larry B.

You can reinstall your paretalogic software.
ParetoLogic - Products

That will most likely fix it.

When your PC starts it tried to load a program called "ParetoLogic DriverCure", but it cannot find it, most probably as it was uninstalled at some stage from your PC or if you still have it installed, its installation is corrupt.

If you still have ParetoLogic DriverCure installed and still use it, then reinstalling it should fix any problems

Or

If it was uninstalled, then there are a file or two still remaining as the uninstall was not any good, click START / RUN and type MSCONFIG in the box and click OK. Click the "Startup" tab, in this list of programs you are looking for "ParetoLogic DriverCure" (it might be abbreviated), look under manufacturer, when/if you locate it, untick the box next to it, then click Apply, then click OK, you will be asked to restart your PC, do so, after your PC restarts a dialog box will appear, click OK to confirm.

To sort out this problem you need to do few steps> go for msconfig, click on the start button>run>type-msconfig>select the startup option> check the any rundll entry enable, then disable it and click OK, reboot the computer.

May be this file correcpted by virus, malware and spyware please scan with some power full anti virus and Malwarebytes.