Sure hope you can help I just about run out of ideas. First symptoms. Dryer just shut down no light of anything. At suggestion of a friend I shut of the circuit breaker for 10 minutes turned it back on and it worked. Ran for about 20 minutes then shut down. It was suggested that I replace the thermistor which I did. Worked one day then stopped. I was told it was probably the control panel so I bought a new one out $104.00. Worked 2 days and then when I got up this morning it was off. I've checked heater it shows continuity shows 0 ohms manual says it should be between 7-10 ohms. Anyway to check this closer. Is there anything else that would make the heater show bad??

Copbond1

I have a problem some what similar to yours today.
The four pins plug is old. It get very warm the rubber was getting soft after the dry run for a while and lost connection, dryer stop no light nothing. Replaced okay now

Are you talking about 4 pin plug on control board??

copbond1

NO, the big black one that plugs into the wall outlet.