I have a house that is 4 1/2 years old. I am on city water and all of a sudden about just over 1 month ago I started having a banging problem on the major water intake Valve into the house when I flush the toilets, washer starts filling up with water, turning on the Taps in the basement. This problem is gradually getting worse. Any thoughts on how this could be fix


Regards, Peter

Quote:

---

Originally Posted by pmelong

I have a house that is 4 1/2 years old. I am on city water and all of a sudden about just over 1 month ago I started having a banging problem on the major water intake Valve into the house when I flush the toilets, washer starts filling up with water, turning on the Taps in the basement. This problem is gradually getting worse. Any thoughts on how this could be fix
Regards, Peter

---

Hey Pete,

This isn't a "air lock" problem. What you have is "water hammer". Read on.
Back in the 60's we were required to to put shock absorbers,(air chambers) on all bath lavatorys and kitchen sinks. Over time water and condensate built up in them and they must be recharged. First turn off the house at the main house shut off valve. Then open hot and cold faucets at the farthest bathroom to prevent air lock.(This is important.) You will find under each fixture little brass or chrome valves. These are called angle stops. With a small pail held under the angle stop to catch the run off look under the handle of the stop and you will see a nut with the stem running through it. This is called the bonnet packing nut. Put your wrench on it and back it off counterclockwise. Now open the stop and remove the stem and washer assembly, The stop will begain to drain. When it has quit draining reassemble the stop and move on to the next one. Do this on each one of your angle stops. There will be six of them. When you are done, close off the faucets you have opened, turn on the water to the house, and give yourself a pat on the back.
You have just recharged your air chambers and saved yourself a hefty service call bill. Good luck, Tom

Hi again

I did what you suggested and the same problem is happening. I had mentioned that the noise is centered at the major intake of the house. This intake is attached to the meter and it sounds like it coming from the meter to be honest. Any suggestions as to what action I can take!

Quote:

---

Originally Posted by speedball1

Hey Pete,

This isn't a "air lock" problem. What you have is "water hammer". Read on.
Back in the 60's we were required to to put shock absorbers,(air chambers) on all bath lavatorys and kitchen sinks. Over time water and condensate built up in them and they must be recharged. First turn off the house at the main house shut off valve. Then open hot and cold faucets at the farthest bathroom to prevent air lock.(This is importent.) You will find under each fixture little brass or chrome valves. These are called angle stops. With a small pail held under the angle stop to catch the run off look under the handle of the stop and you will see a nut with the stem running through it. This is called the bonnet packing nut. Put your wrench on it and back it off counterclockwise. Now open the stop and remove the stem and washer assembly, The stop will begain to drain. When it has quit draining reassemble the stop and move on to the next one. Do this on each one of your angle stops. There will be six of them. When you are done, close off the faucets you have opened, turn on the water to the house, and give yourself a pat on the back.
You have just recharged your air chambers and saved yourself a hefty service call bill. Good luck, Tom

---

Call the utilities company and have them replace the meter. If this is the source then it becomes their responsibility. Good luck, Tom