How do I install heating element in Kenmore Elite Dryer model #11084836200
Help?

2krazy4kids - did you take the old one out?? is this a new one? Ok im going to try to lead you through putting it back in the dryer , 31 take and put the element back into the canaster the old one came out opf , put the screws back in to hold the element in place in the canaster , :: #2- now
Slide it back up inside the back of the dryer, you should have two screws that hold the canaster in place in side the dryer put them #3-
Re hook up the wires to the heat protector <it is on the out side of the canaster the element is in . 34 - now lets replace the back panel you took ofgf to get to the heating element, put zall the screws back in the panel , hook up the power cord and hook up the vent that goes outside ,:: now
If you done it right turnit on and see if you have heat inside after it runs a few minuts << open the door and put your hand inside thr dryer and see if you can feel any heat inside , if you did then you done a good job , feels good to know you done it all by your serlf ;;
Have a grerat day and god bless ::: f.b.e.