Hi,
I have a Kenmore Ultra Wash Dishwasher (665.15822000) that is about 8 years old. It has started running for about the first 10-15 minutes of its cycle and than going to 2 min remaining on the digital display and ends leaving the hi temp scrub light flashing. I reset it about a week ago using the tips on this site, hi temp scrub - air dry 3 times and the unit worked for a few cycles. I also reset the breaker at that time. Now it is doing the same thing. Does anyone have any ideas for moving forward with the diagnosis? It's been a good dw up to this point, and I'll probably sink a little $ in parts into it before I replace it. Any help would be appreciated.

The DW runs a complete cycle in china/gentle with the air dry selected which I think does not use the heating element through the whole cycle. The heating element is about 50-60 bucks at searsparts and if it will get me a year or two it's worth it. Has anyone seen these symptoms? Its an Kenmore Ultrawash 665.16822000.