Hi
I have a top loading 110 series Kenmore washer. I replaced its coupler and it was laying on its side for almost one week till that coupler arrived. I also tried to separate drum from coupler which was not successful. So I removed motor from bottom and replaced coupler.
Now it works fine but at high spin cycle it jumps and walks in the room. It is on hard surface and I have leveled it too but nothing worked.
Its washer drum is very loose and looks like sitting on springs only.
Any suggestions or expert advice will be appreciated. I have done lots of other stuff but this is my first time messing with washer.

If you open the lid and move the tub does it move freely or have restrition to it