Ask Me Help Desk - Water leak and mold forming

Quote:

Bathroom #1 is a tub and tile and the grout is 12 years old. I did notice a few areas where the grout appears to have tiny cracks, which could be the source of a leak. This bathroom shower gets used very frequently (more than once per day.) Should I re-grout this bathroom and call in a professional re: black spots?

If you're handy you can remove the old grout where the shower stream hits the tile and regrout. I'll address the black spots later on down the line.

Quote:

Bathroom #2 is a shower only with tiled walls and a separate plastic or fiberglass base. I found a few spider cracks in the base. I re-grouted bathroom #2 about 1 year ago using a laticrete product which turned out very good. I don't think I repainted the water stain since then, and it really hasn't changed much or gotten larger.

If you don't have a leak and the spots have dried out then why not simply paint over the spots? ( If it ain't broke why fix it? )

Quote:

Could I change the shower base without ruining the tile work?

No! The tile overlaps the base so some tile will have to come out and be replaced.

Once you have mildew or mold, even if you are able to thoroughly clean the grout, you will always have to battle it. Mildew send out millions of tiny spores (seeds) that can lie dormant for a long time. Once moisture and their food source is present, mildew pops to life and send out more spores into the air.

In addition to the mildew, you may have some hard water stains (primarily calcium deposits) on the grout. You will find this out as you attempt to remove the mildew because the cleaning procedures for the two are different. Also, you may have to treat the dull tile differently than the glossy tile.

First, go to your hardware store and buy a good quality scrub brush with stout plastic bristles. The bristles may feel very stiff, but they should not scratch the very hard tile surface. Use abrasive cleaners, even mild ones, as a last resort. Repeated use of these can dull all the tiles.

On your way home, stop at the supermarket and pick up some standard chlorine bleach, white vinegar, rubber gloves and rolls of paper towels. You might also check out some of the common tub and tile cleaners that indicate that they are effective for cleaning the grout too.

Almost all of the common ones are safe to glossy ceramic bathroom tile. The dull, softer tile may or may not be a different story. You should test the cleaners on small areas first or contact the company and ask them about it.

Here are a few of the common bathroom cleaners to consider and to call about - Mist Away by Reckitt & Colman (800-228-4722), Comet by P&G (800-926-9441), Tilex by Clorox (800-227-1860), and Original Clean Shower by Church & Dwight (800-617-4220).

Use one of the above cleaners and the scrub brush to remove as much of the mildew and any scum on the tiles. If you are having problems cleaning the tiles, it is probably hard water deposits. These are as hard as a rock.

Soak some paper towels with white vinegar and lay them over the tile and grout. The wet towels will cling to the vertical wall tiles. It will likely take many hours to soften the deposits. Check the paper towels every two hours to make sure that they are still wet with vinegar.

Rinse the walls thoroughly to make sure that all the vinegar is off and dry them. Wear your rubber gloves and saturate more paper towels with chlorine bleach. Place these against the grout and let the bleach do its whitening work for hours. This will also kill all the mildew.

In order to minimize the future growth of mildew on the grout, take away its nutrients and moisture. Rinse the walls when you are done showering and then run a shower squeegee over them. It only takes about 30 seconds. Leave the shower curtain or door open to hasten the drying time.

Tools and materials required: scrub brush, shower squeegee, paper towels, cleaner, vinegar, bleach.
Hope this helps , Tom