I have replace a seized up motor this weekend. Motor would not run. Talked to a HVAC man who lives far away, explained the board is shot.

Today I replaced the rodgers-white circuit board.

Need help in connecting the motor wires. The two brown are connected to the capacitor.

Black to cool-H red to park and blue to park. Yellow to cir.

Fan comes on when I turn it on. Shuts off when I try to run the air conditioner. Haven't tried the heat yet. It's 110 out side. Are these the correct way or Did I do something wrong.

I get a steady flashing light from the board indicating everything is fine.

This is for a trane unit model#tue060a936ko

Read the papers that came with the new board. Usually they are packed with the board because the boards are updated all the time and wiring can change.

See page 11 below and read the notes


http://www.aireng.com/clientuploads/...urnace/tue.pdf

One more thing. I was told by the supply store that the Yellow wire would replace the white wire from my old motor. Is this correct or do I follow the colors on the diagram you linked me to.

Thanks

That is hard to tell and it is possible. Read the side of the motor. They all have a diagram. I am not there to look at the situation.