I need some advice on how to wire a non-fused 60 amp disconnect. I will be using it to disconnect a heating element. My question is this: There are two line and load posts. I am assuming the two load post will go to the element, but I am not 100% sure. I am using 6-2wire. Any assistance would be greatly appreciated.

Your correct. Line is from the fuse box. Load is the element.

Thanks!

Yes the line come from panel .load go to element

Tony please pay attention to the dates of threads, this goes back to 2008.

Please refrain from answering questions older than a few months.

Thread is closed.