I have checked a lot of sites on how to remove the ceiling fan. I have also followed a number of give instructions. I did all the need steps and have reached a dead end the ceiling fan won't come off. I am attaching images of where I have reached, any help would be great, before I break it off. - Thanks

If you can't find any other fasteners holding it on do you have attic access to look at from above ? What type of fan is it if you know it looks older to me ? If it were me I would try to get at it from the attic if I could at least to see how its connected it should be attached to an electrical box in some way but I have seen some screwy installations. Post back and let us know. GOOD LUCK AC

There are some fasteners on the very top part near the ceiling. Carefully loosed then and see if the unit will slide down. There should be enough room to unhook the fan motor assembly from it's anchoring point. MAKE SURE THE ELECTRICITY IS TURNED OFF AT THE CIRCUIT BREAKER BEFORE DOING ANYTHING!!

Where are these fasteners?

Look at your photos. There are three "studs" sticking out around the top of the plate... they should thread off

Those studs had locknuts which I have removed. The base plate just moves (rotates) slightly, but nothing more

RM08,

At the bottom of the fan assembly is the light package. Carefully move the wiring out of the way and you should see at least two screws in slotted cut outs. Loosen the screws and let the fixture asm. Drop down.

What is the motor mounted to? Do you see a shaft or rod running down through the motor? See if you can lift and twist the motor to release from its mounting. Remember, motors are heavy so be prepared for the weight.

The two cowlings pictured seem to be for decoration only. Neither seem to have the strength to support the motor.

Let me know how it goes.

Any luck with that ceiling fan ? Can you get above it?

Those studs at the top, where you removed the lock nuts, are where the fan housing mounts. With those nuts removed, and the washers removed, the fan comes off those studs.
I am surprised it hasn't fallen down by itself!

You disassembled way more than you needed to. The blades and those three nuts were all you needed to remove.

Stan,

Those do not look like mounting screws. They appear to be nothing more then bezel screws.

That housing sits on top of the fan motor assembly. Until the fan motor is released, the bezel will not drop down. At least that's MPO.

I have removed/pulled down the light fixture. I don't see any pins, neither is the motor lifting up the shaft. But I do see 3 screws on the top side of motor casing, hard to reach.

Stan that's what it looks like to me also. I think those look a little big for just bezel screws but its hard to tell from the pic. I think I would try gently pulling down and twisting slightly at the same time maybe the housing is wedged on the threads of those studs. Anyway guess well wait to hear back from RM08

AC
I haven't had a chance to get to attic, but that's part of my plan.

I have tried turning, pulling down, shifting side ways - no luck

Just keep us posted we will get it down. What about those hard to reach screws you found ?

AC
No luck from the attic, there is a block of wood across, so no access

I 100% guarantee that those studs are the housing mounting studs. With the nuts removed the whole thing will come down.
Why it doesn't for you is a mystery.

Did you try and get those lock washers off? It looks as if they might be wedged on there. Try to pry off the washers and see what happens.

Great! I removed the washers using a chisel and down came the whole thing. Stanfortyman, ac101, donf and handyman2007 - Thank you so much for your patience, advice and sharing of knowledge. I will now be installing a new fan and I hope it won't be as difficult. Once again, much appreciate your help.
RM

GOOD JOB if you have anymore trouble were here. AC

Thank you again!