Hi, Installed a digital thermostat, replacing a manual one. The fan worked for a short time, then switched to heat mode and it didn't work. Found I had it wired one wire wrong, Wired it right, then nothing, Could this cause damage to my unit? I put the old one back on it still doesn't work. I have a heat pump and bought a ritetemp thermostat 6020.

Quote:

---

Originally Posted by planoman

Could this cause damage to my unit?

---

Most probably the incorrect installation destroyed the new thermostat. Just replace it again. Properly this time...

:)

Check for a blown fuse on the indoor unit circuit board. Also check to see if you still have 24 volt control voltage.

The RiteTemp Support Site - 6020 Technical Support Page please vist this site and probably it can solve the problem

If the site take awhile refresh it then it will work tell me if the site was great by sending me a privat message