Hi there, I am brand new to this site and hoping someone out there can help!

I have a 1988 Cadillac fleetwood, V8 front wheel drive with digital dashboard, I took it to a GM dealer to have the car programmed for the new keyless remote I got to replacehe busted one, but after an hour, they came to me saying they had no clue how to do it! How can that be? They are a dealer, OK not a cadillac dealer, but GM dealer all the same, I thought they were the ones who could fix any GM problem, oh well, I am hoping that someone pout there can tell me how to program my caddy! I have had a couple of suggestions, but neither worked, first was to bridge two terminals on the adsl plug under the dash, and another was to hold two buttons on the digital heater controls, which puts it into diagnostic mode, but the code they mentioned didn't even show up, so I am now completely lost, if a gm dealer don't know, what chance have I got? Any help most gratefully received, many thanks, in advance, CC:)

Well, you're in luck. We have someone here that I know can help you. He's the Captain when it comes to Caddys. So hang in there, don't go messn' with any wires just yet. I think I see him now.
Oh Captain, oh CaptainRich? Your services are needed...

Oh... and welcome to the forum.

Bump

Thanks for the bump, kitch!

First thing I need you to do, CC, is to look in the trunk. Remove the plastic cover from the rear area of the trunk opening and see if there is a single wire with a black plastic terminal that leads to no-where (often found just right of center under that cover). Let me know if you find it. Otherwise, some of those do program through the data link connector or scan tool.

CC, from whom did you get the new remote? Is it original equipment or more likely an aftermarket accessory?

In defense of GM techs, all are not wise to Cadillacs.
Cadillac's are a totally different breed than say, a Chevy or a Buick even.
It's best to take your Chevy to a Caddy tech, than your Caddy to a Chevy tech, generally speaking.

Hi there, well I am going to look real dumb now, I had a look in the trunk, behind the carpeting, (I don't have any plastic in the trunk that I can see) I couldn't see any wires that didn't seem to go anywhere, they all went somewhere, even the real skinny one all on it's own over the right rear wheel arch, went into the rear panel for something! So am I looking on the right place?? I have a haynes manual for it, but it doesn' mention programming the remote, so which piece of plastic do I have to look out for?

Helloo? Anyone there?

Wish I could help you, dude, but know nothing 'bout Catteracs.
I'll bump it up a notch.

Attachment 7272

Quote:

---

Originally Posted by CaptainRich

.....some of those do program through the data link connector or scan tool.

CC, from whom did you get the new remote? Is it original equipment or more likely an aftermarket accessory?

---

Just wanting to make certain we're attempting to program a factory system.
I don't recall any remotes for this model year... but then it's been a while since having seen that model year.