Water drip into the furnace, and it is not lighting now to give heat to the apt. It is a York Stellar. The glow bar get hot and then it light for a brief moment and then go out. I change the glow bar, the power pack, but it still not staying on to heat the apt. Any help is greatly appreciated.

Lee

Lee - Just where did the water drip into the heater at?? Did the water drip down into the openings where the gas comes out and burns ? Do you approx. know how much water got inside the heater? Did you check the thermostate probe, IF the probe is stopped working, it will not stay light Good LUCK & GOD BLESS :::: F.B.E.

If your unit has a flame sensor take it out and clean the metal part with sand paper.

Quote:

---

Originally Posted by Flying Blue Eagle

Lee - Just where did the water drip into the heater at ??? did the water drip down into the openings where the gas comes out and burns ? do you approx. know how much water got inside the heater? Did you check the thermostate probe, IF the probe is stopped working, it will not stay light Good LUCK & GOD BLESS :::: F.B.E.

---

F.B.E.
The water drip in from the duck on the front top. It also went to the area where the power pack is. I swap out all those parts and they work on the other unit. Now it is not lighting.

Quote:

---

Originally Posted by leeall

Water drip into the furnace, and it is not lighting now to give heat to the apt. It is a York Stellar. The glow bar get hot and then it light for a brief moment and then go out. I change the glow bar, the power pack, but it still not staying on to heat the apt. Any help is greatly appreciated.

Lee

---

After allowing it to dry out, including the resistor, it came on and stayed on. Thanks for your help.