Help:

The reading on my CT3200 is higher from the room temperature by at least 2 degrees Celsius during the heating season. I measured the temperature with a digital thermometer which read 20 degrees Celsius and my CT3200 was reading 22 degrees Celsius. It's on an inside wall which is well insulated with no drafts.

How do I get the correct reading on my CT3200?

There may be no drafts in the room, but have you checked to ensure there are no drafts coming through the wall where the wires attach to the thermostat? Maybe plug the hole with insulation or what-have-you. It doesn't take much of a draft there to make a difference.

If this doesn't solve the problem there there are only two options: 1) replace the thermostat (perhaps call Honeywell for a warranty replacement?) or 2) turn your heat down to compensate for the inaccuracy. There is no way that I am aware of to re-calibrate a digital thermostat.

I have a magicstat/32 and I want to operate a hot water unit heater is it possible to run furnace and fan for heater on this thermostat/

Quote:

---

Originally Posted by jbsimpson

i have a magicstat/32 and i want to operate a hot water unit heater is it possible to run furnace and fan for heater on this thermostat/

---

The thread you put this in want get read by many people,, its 3 months old,, you need to start your own thread

I have thermastst magicstat/32 will it operate furnace and a fan.