Kenmore 110.96583220
Sudden death, apparent broken belt, belt replaced, power at wall receptacle, at both sides of blower-mounted fuse and thermostat, door switch OK, pulley motor switch reset properly.

No juice at the motor? (It's not easy to get to to make measurements with all parts assembled).

Any ideas?

Tom

Can you remove the leads from the motor the check power at that point? Jumper around the thermal fuse as well to see if unit will start.

Tom 11 You could have a bad start switch or dryer control switch, if you can check them also , start then control , Doug you gave good answer also , thsat would have been my first guess Good luck ::: F.B.E.

Hey -Esquirel - do me a favor and check out (AMY 1964) On appliances . Thanks F.B.E.

When you replaced the belt did you reset/realign the broken belt switch arm? If not, there is your problem.