I have a GE washer that will not engage and spin through it's normal cycle. It completes the cycle, the pump drains all the water but it will not spin. All other parts of the cycle seem OK. L not start again. I would like to look inside but am unsure how to make my way in to this machine. Does the front panel pull off for access? It's a GE WWSR3090T8WW. I do not have a manual and that is slowing my quest for an answer down. Does anyone have any experience with this type of machine that could get me inside and point me in a couple directions? I'll gladly provide more details as requested.

Thanks in advance.

Herb.

OK. I got the front cover off and the top off. I did a continuity test on the cover switch and that checks out OK. The drive belt under the tub turns freely but one part in their sounds a little dry/metallic. NOt sure yet what that part is or how to determine if it's good or bad. I ask this as well: Shouldn't the process stop when the cover is opened? If I recall when all was well, the spin would come to a rapid halt when the cover was opened. Now not only does it not turn but the tub seems 'locked' in place as it is not possible to turn it by hand. What process controls this?

Thanks.

Herb.

Well, never mind replying. The machine is disasseblmed and in front of my house awaiting the haulers on Monday. Once inside I found some pretty rusted an d corroded parts which made any further dissasembly impractical. I guess it's off to shop for a new one. Any thoughts on a good new machine.

:-)

The tub should stop when you lift the lid. There could even be a brake to stop it more quick. It is possible the brake is bad. Have you tried turning the cycle knob past the spin cycle and see if things will then work normally?