I need help on how to remove the starter on a 1995 Crown Victoria?

Quote:

---

Originally Posted by ronnyron

I need help on how to remove the starter on a 1995 Crown Victoria?

---

1. Disconnect both battery cables.
2. Raise and support the vehicle.
3. Disconnect starter cable and push-on connector from starter solenoid. CAUTION : When disconnecting hard-shell connector, grasp the plastic shell and pull off. Do not pull on wire. Be careful to pull straight off to prevent damage to the connector and the terminal. If any part of the connection is damaged, replace the damaged components to prevent no-start conditions.
4. Remove upper mounting bolt.
5. Remove lower mounting bolt and starter.
6. Reinstall in the opposite order. Clean the cable terminals and the battery posts before reconnecting the battery.

HEY CAPT> Rich- Very well put , step by step as should be done. Ronnyron- ;; Do the way as cap. Rich has told you and you will come out all right.:::: F.B.E. P.S. 9Always unhook the (neg. post first.) and hook up the same way,Elect. Flows from negative.to post.