Ask Me Help Desk

Ask Me Help Desk (https://www.askmehelpdesk.com/forum.php)
-   Scanners (https://www.askmehelpdesk.com/forumdisplay.php?f=464)
-   -   Microtek slimscan C6 USB connection issue (https://www.askmehelpdesk.com/showthread.php?t=126854)

  • Sep 7, 2007, 06:47 AM
    humoryou
    Microtek slimscan C6 USB connection issue
    I have a Microtek SlimScan C6 USB which is unable to communicate with a Windows XP machine. I downloaded the installer from Microtek (the same one on all the driver sites). When I run the installer I am given 2 port choices 1) Parallel and 2) SCSI. Since the scanner is USB when the installer finishes and attempts to communicate with the scanner it cannot find it when I choose either of the two choices offered. There is not a choice for USB even after the installer is run even though the site lists the USB model as one of the options for the scanner.
    Has any one worked with this scanner? Had a similar issue? Have an installer that can communicate through the USB port?
    Thanks loads in advance. :confused:
  • Jun 9, 2008, 12:37 PM
    Scleros
    old post, oh well...

    I have a ScanMaker X6 which uses the same ScanWizard 2.60 software as your scanner I believe. Installation in XP was problematic...

    If I recall correctly, you had to plug scanner in, turn on, and manually install the driver when scanner was detected from the Windows 2000 folder in the scanner software folder tree (or the driver may have been one built into Windows XP). Then run the installer and choose SCSI (quasi SCSI-USB converter built into driver).

  • All times are GMT -7. The time now is 07:35 AM.