I am trying to wire a chemical feed pump to my pumptrol(fsg-2). I have no wiring diagram.

The chemical feed pump should only pump bleach into my water holding tank when my well pump is running.

The chemical feed pump plugs into an outlet and the outlet with it black, white and ground wires tie into the pumptrol.

There are 4 terminals on the pumptrol. Line, load,load and line. So where do I place the black and white wires in relations to line and load terminals?


[email protected]

If what I am thinking, 220/240 volts to both line sides, connect pump to load, along with Chemical feed.
Black and white will be on Load side. Both will operate when pressure drops, and pump turns on.