Is it possible to bend the schedule 40 galvanised pipe to get curve about 30-45 degrees of angle? The temperature of the water flowing in it is max 50 degrees C and the pressure is 6 bars it will be a shower connection between shower nosle and shower mixer.:mad: :mad: :confused: :mad: :confused:

Quote:

---

Originally Posted by enderesberk

is it possible to bend the schedule 40 galvanised pipe to get curve about 30-45 degrees of angle? the temperature of the water flowing in it is max 50 degrees C and the pressure is 6 bars it will be a shower connection between shower nosle and shower mixer.:mad: :mad: :confused: :mad: :confused:

---

Small diameter pipe(1.25 cm) you could a manual pipe bender with a long handle. Why don't you get a 45 degree ell