Ask Me Help Desk

Ask Me Help Desk (https://www.askmehelpdesk.com/forum.php)
-   Electrical & Lighting (https://www.askmehelpdesk.com/forumdisplay.php?f=105)
-   -   Outdoor motion-sensing, photo-sensing wall lantern not turning off (https://www.askmehelpdesk.com/showthread.php?t=11234)

  • Jul 24, 2005, 06:48 AM
    HighRidgeMan
    Outdoor motion-sensing, photo-sensing wall lantern not turning off
    Hampton Bay Motion Sensing Outdoor Wall Lantern #561456

    I installed a pair of these lanterns next to my front door about two years ago, the first one works fine.

    I’ve replaced the second lantern three times so far – when I installed the first lantern it worked fine except the motion sensor was too sensitive. But after a while the lamp stopped working so I replaced it.

    The second lantern also had problems with the motion sensor sensitivity and an occasional problem with the photo sensor – it would sometimes turn on during the day, I replaced it when the light would stay on all the time.

    I installed the third lantern yesterday and the light stayed on all the time.

    What do you think the problem/solution is? I've checked the settings on the lamp and all seems fine. I connected the white wire from the lantern to a pair of white wires from the house and the black wire to a pair of black wires.

    Thanks
  • Jul 25, 2005, 12:06 PM
    Press2Esc
    If applicable, put the motion lights in "test mode" to check bulb, timer circuit and this mode over-rides the optical sensor... It is best to best to check sensitivity and motion (trigger) area near sundown... Note, motion and optical sensors are 2 diff sensors.

    P2E

    Quote:

    Originally Posted by HighRidgeMan
    Hampton Bay Motion Sensing Outdoor Wall Lantern #561456

    I installed a pair of these lanterns next to my front door about two years ago, the first one works fine.

    I’ve replaced the second lantern three times so far – when I installed the first lantern it worked fine except the motion sensor was too sensitive. But after a while the lamp stopped working so I replaced it.

    The second lantern also had problems with the motion sensor sensitivity and an occasional problem with the photo sensor – it would sometimes turn on during the day, I replaced it when the light would stay on all the time.

    I installed the third lantern yesterday and the light stayed on all the time.

    What do you think the problem/solution is? I've checked the settings on the lamp and all seems fine. I connected the white wire from the lantern to a pair of white wires from the house and the black wire to a pair of black wires.

    Thanks

  • Oct 21, 2007, 02:06 PM
    qpackard
    I have the model HB 248-523 with the same problem. After exhausting my vast intuitive knowledge I read the instructions:
    To change between automatic and manual mode turn the lamp off and back on within three seconds to reset the mode.

  • All times are GMT -7. The time now is 03:22 PM.