I have a ceiling fan that is operated by a Litex remote control. It was working fine. I replaced the nine volt battery, but after reconnecting the connections it does not work! The fan will not go on. The display screen on the remote has an image of a battery in the right corner that shows a battery that has an X through it and this pulsates slightly, The light indicator shows up at 188% of capacity and the indicator for fan speed is on high.

There is a small switch board with small slots just above the wires. I did notice the second slot had its switch pulled down , but resetting that or manipulating other switches in different configurations had no effect.

Any ideas?

If those are DIP switches, they need to match the fan receiver.
Verify you have a good battery.

Basically, yes.

Are you sure the original battery was the problem, and not the remote itself? What was it doing RIGHT before you replaced the battery?

Ceiling fan remote controls - help and FAQ- Ceiling Fans N More