I am planning to replace my water inlet valve of my referigrator ice maker. I am confused with the electric connection. The +ve or -ve is not marked on the referigrator side or valve side. Please advice how to find this. Or Is it OK if I connect it anyway?

Thanks
Sam

Is this a single or dual valve? Single valve doesn't matter.

AC doesn't have + and -. Where you just have a coil, hot and neutral doesn't make much difference after the switch. Hot is always switched.

Quote:

---

Originally Posted by esquire1

Is this a single or dual valve? Single valve doesn't matter.

---

It's a single valve.
Thanks

Plug it it and let it make ice. You are good to go

Quote:

---

Originally Posted by labman

AC doesn't have + and -. Where you just have a coil, hot and neutral doesn't make much difference after the switch. Hot is always switched.

---

Yes that's what I meant to say. I have hot and netural from the refrigator side and two points in the inlet vlave. Doest it matter which one should go to which point?

Thanks