Heil Furnace Has Extra Dangling Wire for Terminal Block
I have a Heil 20 + Year Old Natural Gas Furnace Model NUGE125BH02 with a York Air Conditioner of same age. Just replaced filter and saw a Red Wire Dangling with 'Move to Change Cooling Speed' on it. The furnace diagram does not show a red wire. Only Violet and Yellow and White Ground. I don't know if I pulled the red off when I changed the filter or if was always loose. My Yellow is attached to the Hi Setting, the Violet is to the interlock, unlike the manual. The White Ground is OK. The Red Wire is just dangling. Should I attach it to the Med/Hi Setting or let it just dangle? The Heater works fine. Thanks in advance... Bob
Comment on BobKusnirik's post
Hope we were helpful. You can "tip" me by checking YES-is this helpful in my posting. Brian
Comment on BobKusnirik's post