Working with Brazilian Cherry planks
I am in the process of making a table top from 3 1/8" Brazilian Cherry planks that I got from Lumber Liquidators. The same material one would use for hardwoor floors.
The table will measure 53" square with a removable center piece which is 16". I have glued the three sections that make up the table top using Franklin's Wood Glue, clamped, and now ready to finish.
I have read a few opinions online how to finish the wood. Some say use a random orbital sander while others say do not use a belt sander. My thought was to use a 4X24 belt sander to remove the initial stock to achieve a level, smooth table top with 80 grit.
Floor sander contractors use belt sanding machines which are much larger of course.
I am thinking of using Minwax Red Mahogany stain and finish with two coats of Minwax polyurathane.
- What would you suggest is the best method for finishing unfinished Baravian Cherry from start to finish? I want to finish the table with a satin sheen. Plan to use belt sander 80 grit, followed by 120 grit. Then switch to random orbital sander with 180 grit then 220. Stain top and after drying, coat with sanding sealer. Finish with 320 between coats.
- Do you think it is necessary to wet between coats of 320 or higher?
Thank You,
Jim