Concord 80 plus air handler blower motor does not run in cool mode or heat mode.
Shut off furnace switch to service coil. Coil is clean, replaced covers and turned on furnace switch and now the blower /indoor fan will not run. No power from control board at terminal marked"cool" placed it on terminal marked continuous and will run. Could this be a bad solid state relay K2, should I try to find this relay which is hard soldered to the board or should I buy a new control board, also blower does not run in heat mode either. Condenser and outdoor fan work. Blower stopped working after I shut off furnace switch and turned it back on after service.