I need some help finding out where this loose wire should go. We have a 9 year old house and lennox gas furnace 80MGF series. Were not getting heat, it has a slow flash(no call for heat)on the LED code. The emergency heat will ignight the burners and we can get heat that way, but I don't want to run it to long in that mode.
The blue wire is from a{sensor/switch or relay ?}a 2"x2" black componet, with terminal clips1 and 2 on the top and 3 & 4 on the bottom corners. The loose wire comes from the #2 terminal. Thisrelay is located a few inches to the right top of the circuit board.the label on it says48G901 24vac 50/60hz 3a 277vac coil products products unlimited.
I'm having problems following the wiring diagram, doesn't say blue wire or show clearly the 2 relays next to the circuit board.anyway thanks if you can HELP.
Craig / New member / 1st Question.