Trouble with DSC 1832 programming
Recently I have installed dsc 1832 security system . So far I have done good. But I can not solve my smoke detector problem .
Smoke detector is FSA-410BT 4-wire .
I have run cat5 wire for this connection . The reason is simply - I had left over cat5 .
I have used Bro for 12v+ and BLU for GND. So I have connected BRO to Aux+ and BLU to PGM2.
I have used ORG for NO and GRN for C terminal.
I have put 5.6k resistor across NO and C inside Smoke detector.
I have used zone 15 for this smoke detector .
I have programmed sone 15 as 08 ( std. hardwired 24hr fire).
I have programmed PGM2 output as 03
I can arm the system but it show FIRE ZONE as zone fault. What could be the problem ? Is there anything which I am missing or did not do right ?
Any suggestions will be greatly appreciated
Thanks
Pk