Iron or alum.railings in limestone
Hello, was wondering the average cost material and labor for drilling limestone tread/border on top.. it would be a straight run four feet on from pavement, I have three tread slabs (first tread will be drilled center top border is limestone for the top rail of three feet to siding. So I'll have a total of six holes to drill into 2" limestone.. I have never done this before but it seems easy once I get the centers from the siding.. alum needs a bigger masonry bit than if I were to go with rails iron smaller masonary bit.. anybody have any suggestions? As for costs and what is best to use? Note the house will be selling in a few years.. so I want to go the cheaper route.. I already looked at crap Lowe's had in stock and wouldn't dare using it on four ft off the ground . Thanks ahead, jon