Ask Me Help Desk

Ask Me Help Desk (https://www.askmehelpdesk.com/forum.php)
-   Tools & Power Equipment (https://www.askmehelpdesk.com/forumdisplay.php?f=334)
-   -   I need a diagram to install a drive belt on a John Deere 185 Hydro. (https://www.askmehelpdesk.com/showthread.php?t=357174)

  • May 23, 2009, 08:38 PM
    scarecrow072
    I need a diagram to install a drive belt on a John Deere 185 Hydro.
    Any helpful info on this would be appreciated.
  • May 26, 2009, 08:27 AM
    ballengerb1

    Start your search here john deere belt diagram - Google Image Search
  • Aug 5, 2009, 11:48 AM
    topherjn88

    I have a john deere 175 hydro should be very similar check out this site
    Installation of John Deere 175 Lawn Tractor Drive Belt
  • Aug 5, 2009, 02:21 PM
    crigby

    Hi,
    Pictures available at both are for the 165, 175 and 185 hydros with Eaton pump/motor drives mated to a Peerless transaxle. The one at outdoorpowerinfo.com has several pictures from various angles and while it is not an original equipment belt, it is a fairly bright blue because of the sheath and quite visible.
    This is not the only one! A very few late versions of all three models had TuffTorq by Kanzaki transaxles; so be warned.
    Peace,
    Clarke
  • Aug 9, 2011, 11:37 AM
    JDPeoples
    My 185 is a 1990 model with the Tufftorq. There is no idler near the engine because the trans pulley shaft is vertical like the engine, so the belt clears the steering shaft. Still need to remove the steering support bracket. Also don't need to remove trans shaft pin and clevis since belt doesn't run up along the side of the trans, it's on top.

  • All times are GMT -7. The time now is 04:12 AM.