Originally Posted by rpg219
Hey ya'll.....had to get up when I realized that Colton has no clean clothes for tomorrow, lol.
Guy....no vid of it, but here you go:
With the bill face up fold the top down and the bottom up so they meet at the crease in the middle.
Fold the top and bottom in a second time to meet at the center crease and run a short ruler or a credit card along the folds to make a sharp crease. Then unfold these second folds.
Now fold the dollar in half, back to back so the sides meet.
Now crease the folded edge of the dollar by folding in the corners to the center crease and unfolding them. Then you tuck the creased corners to the inside, between the two layers of the bill. So now you have a dollar with the folded center coming to a point.
I hope you can understand this without pictures--this is where it gets tough to explain. Fold the upper layer of the bill in half so that one edge of the bill is now near the pointed center of the bill.
Then on the quarter of the bill that you just folded, you fold the upper edge down and lower edge up to the center again.
Now turn it over.
Again fold the upper edge down and the lower edge up to the center.
Turn the dollar over again.
Hold the bottom layer of the dollar secure, and carefully pull the top layer open. If you were able to follow my directions successfully, you will now see the dime box.
Make sure the bottom of your box is flat (push it down with your pinky), and place the dime in the box. Smash the edges of the box over the dime to hold it in place.
Tuck the long end of the dollar into the folded part of the short end. Once you have it properly sized, you may want to tape it together so that it does not keep slipping apart when you wear it.
Now to put the clothes in the dryer and off to bed...again. Night everyone HUGS and all that good stuff :)
