Ask Experts Questions for FREE Help !
Ask
Page 1 of 2 1 > Last»
    Hondagirl615's Avatar
    Hondagirl615 Posts: 11, Reputation: 1
    New Member
    		  
    #1

    Mar 26, 2011, 09:04 AM
    2001 Honda CR-V stalled and won't start again?
    My 2001 Honda CR-V stalled at the stop sign and won't turn on again. When we turn the key it doesn't make any noise. At position II the check engine light goes out after 2 secs. Does this mean it is definitely the distributor?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Mar 26, 2011, 10:48 AM
    Could be the battery. There is enough power for the guages but not enough to close the solenoid.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #3

    Mar 26, 2011, 11:28 AM

    If you are saying it cranks but won't start and the CEL is operating normally, then, yes, I would focus on the distributor. Replacing the Ignition Control Module (ICM) and coil will likely solve the problem:

    https://www.askmehelpdesk.com/cars-t...tml#post265896

    If the starter motor doesn't run, then this link should help:

    https://www.askmehelpdesk.com/cars-t...tml#post235560
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #4

    Mar 26, 2011, 12:46 PM
    Comment on TxGreaseMonkey's post
    Says "when we turn the key no noise". That's why I thought battery.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #5

    Mar 26, 2011, 12:50 PM

    You may be right. Because of the talk of the CEL working and the distributor, I thought I would cover all bases.
    Hondagirl615's Avatar
    Hondagirl615 Posts: 11, Reputation: 1
    New Member
    		  
    #6

    Mar 27, 2011, 07:31 PM
    Comment on TxGreaseMonkey's post
    The battery is 2 years old. Would the battery cause the car to stall while driving and just coming to a stop? TxGreaseMonkey I read through a some of your comments with another driver that had a somewhat similar problem and you meantioned the distributor. So I tried what you said about position II and the check engine light and it did go out after 2 seconds. I would love if it's just the battery, but is there anyway to definitely know if it's something like the distributor? Also, the tow truck driver said there is a chance it can be the timing belt. What are your views on it being the timing belt? I really hope it's not a timing belt. Thank you everyone for your input.
    Hondagirl615's Avatar
    Hondagirl615 Posts: 11, Reputation: 1
    New Member
    		  
    #7

    Mar 27, 2011, 09:36 PM
    So the update is that I tried to start the car and it almost started. So this time there was definite sound. I'm going to check the battery tomorrow.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #8

    Mar 28, 2011, 06:52 AM

    Most auto parts stores will test and charge batteries, which tend to last about 4 years, for free. If the car starts, after installing the battery (attach the negative battery cable last), have an auto parts store test the alternator for free.
    Hondagirl615's Avatar
    Hondagirl615 Posts: 11, Reputation: 1
    New Member
    		  
    #9

    Mar 29, 2011, 12:39 PM
    Well, It's not the battery... Brought it to an auto parts store and it's 12.4AMps
    Hondagirl615's Avatar
    Hondagirl615 Posts: 11, Reputation: 1
    New Member
    		  
    #10

    Mar 29, 2011, 12:40 PM
    Comment on TxGreaseMonkey's post
    Well, It's not the battery... Brought it to an auto parts store and it's 12.4AMps
    Hondagirl615's Avatar
    Hondagirl615 Posts: 11, Reputation: 1
    New Member
    		  
    #11

    Mar 29, 2011, 12:41 PM
    What should I check next the distributor or the alternator?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #12

    Mar 29, 2011, 12:52 PM

    Do you mean 12.4 volts? Did they place it on a battery charger? If so, how many amps did it draw? I'm skeptical they tested it properly. Some auto parts store clerks know little and are dangerous in diagnosing almost anything.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #13

    Mar 29, 2011, 01:02 PM

    See if the battery cranks the starter motor. Then, see if the CEL comes on and goes off normally when the ignition switch is turned to Position II. If it does, then I would replace the Ignition Control Module (ICM) and coil:

    https://www.askmehelpdesk.com/cars-t...tml#post265896
    Hondagirl615's Avatar
    Hondagirl615 Posts: 11, Reputation: 1
    New Member
    		  
    #14

    Mar 30, 2011, 09:56 AM
    Well, we are going to be changing the ICM and coil on the distributor as soon as the parts come in. Thanks for your help. I'll let you know how it goes after we get it in.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #15

    Mar 30, 2011, 10:01 AM

    It's very important to remember to apply the silicone heat transfer compound to the back of the new ICM. Ask them to give it to you.
    Hondagirl615's Avatar
    Hondagirl615 Posts: 11, Reputation: 1
    New Member
    		  
    #16

    Mar 30, 2011, 09:03 PM
    TXGreaseMonkey We changed the ICM and Coil and nothing. Still doesn't start. Any other suggestions?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #17

    Mar 31, 2011, 07:47 AM

    Perform the tests in the link below:

    https://www.askmehelpdesk.com/cars-t...tml#post229012

    If the under hood and under dash fuses are good, the CEL comes on and goes off normally, no codes were thrown, and the starter motor cranks, the problem is still likely with the distributor. The internal sensors (CKP, TDC, and CYL) may be bad, which is common on Hondas. Install your new ICM and coil in a new genuine Honda distributor housing and your CR-V should run like a top. Progressing in this fashion you have not wasted any money.

    Here's how to properly install a Honda distributor:

    https://www.askmehelpdesk.com/cars-t...tml#post288473
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #18

    Mar 31, 2011, 12:40 PM
    Comment on Hondagirl615's post
    Better be a lot more than 12.4 Amps!! Even 12.4 volts is a bit low. Alternator should produce 14V and depending on the rating, 45-60+ Amps.
    olatwice's Avatar
    olatwice Posts: 2, Reputation: 1
    New Member
    		  
    #19

    Jun 6, 2011, 06:31 AM
    I have a Honda CRV, 2000 Model. Last week the it suddenly refused to start at the Car Park but the Engine turns. I have changed the battery, the Fuel Pump and the distributor and still won't start but turns and still no spark to the Plugs. Someone advised me that it could be electrical fault or maybe the Distributor is deffective. Please can you help. Thanks
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #20

    Jun 6, 2011, 06:47 AM

    Perform tests in the link below:

    https://www.askmehelpdesk.com/cars-t...tml#post229012

    Over 50% of new aftermarket distributors for Hondas don't work at AMHD. I only recommend genuine Honda distributors. If it's not too late, consider installing a new ICM and coil in your old Honda distributor housing. My bet is that you definitely have a distributor related problem, especially if the Check Engine Light comes on and goes off after 2 seconds, when the ignition switch is turned to ON (Position II).
Not your question? Ask your question View similar questions
 
Page 1 of 2 1 > Last»

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

1998 Honda Civic stalled and won't start [ 8 Answers ]

Read the thread for 2009 titled "Honda Civic Won't Start After Throttle Body Cleaning." I'm having the same problem. My 1998 civic has been stalling at idle on and off for over 3 years. Cranks right back up, though. My CEL is on all the time, but the codes point to the upper O2 sensor, which...

1999 Honda Accord EX V6 engine stalled and hard start after stop for refill (occasion [ 2 Answers ]

• I live in Owatonna, MN and work in Bayport/Stillwater, MN (92 miles each way) • I have a 1999 Honda Accord EX, V6 Coup. I bought it new. • I put in about 255,000 miles already (I was driving 99%) and intend to keep driving it until 500K miles • I still love the car and it is still like brand...

1991 Honda Civic Stalled and now No Start [ 5 Answers ]

1991 Honda Civic DX 4-Door 1.5L Driving 80mph down highway and engine just died. Pulled over and no start. No error codes. Engine cranks, but no indication it will start. On side of road, I was only able to pull distributor cap and check that rotor screw had not come unscrewed again. Where...

91 honda civic stalled and won't start [ 45 Answers ]

Car stalled at a stop light and now won't start. Seems like the fuel pump is working a getting gas to the injectors. Spark is good on all plugs. Tried a new main relay - nothing. Any ideas? ECU doesn't throw any codes.

2001 honda civic won't start [ 1 Answers ]

I have a 2001 honda civic 1.7 dx manuel recently it was broke into and they stripped out were you place the key in the ignition. Well I replaced the ignition unit and connected all the wires to the ignition that I disconnected. Now the engine will rotate but not start does anyone know anyway I...

View more questions Search