I have a BIOS CE1177 and have lost the owners manual. Can someone tell me how to go through setup. I had to replace the batteries on the outside transmitter and now my screen display is all messed up!

Google BIOS CE1177 and you will find someone else with the same proble, and someone who has the manual.

Quote:

---

Originally Posted by normex55

I have a BIOS CE1177 and have lost the owners manual. Can someone tell me how to go through setup. I had to replace the batteries on the outside transmitter and now my screen display is all messed up!

---

I posted an answer to same question for pungoyaker. BUt the key steps are, remove batteries from inside and outside units, plug in inside unit and get flashing IO. With swtich in normal position put batteries in outside unit, then switch it to set ID. Inside unit should stop flashing and show an ID in wind driection pane. Push set on back on inside unit and you should see most everything, but outside data takes a few minutes to show. Set switch to normal again on outside unit, then replace batteries on inside unit too and you are set. Phone for this unit is 1-800-387-8520, no web site for Thermor Ltd.

Hello, I am not sure if anyone has located a manual or not, but I did, its available here...

http://www.thermor-ins.com/manuals/BW953_BW_IB_ENG.pdf

Enjoy!!

Steps that actually work:

1) Remove all batteries (inside and out)
2) Plug in (indoor)
3) Switch on normal (outside)
4) Put in batteries (outside only)
5) Switch from normal to set-Id (outside)
6) Possibly and temporarily move outside device inside next to inside device
7) Once 10 stops flashing then push set-Id button (inside device only)
8) Switch from set-Id to normal (outside only)
9) Replace rain cover (outside)
10)Replace batteries (inside)
11)Push mode button for 3 seconds
12)If F is preferred C then after hitting mode button hit upper left button
13)Done