Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Basement plumbing
[ 2 Answers ]
My house was built in 1950. The finished basement has a room that had a kitchen sink in it. At the (insistent) request of my wife, I removed the kitchen sink so we could move our washer/dryer in there. The drain for the kitchen sink is located on the basement floor. The drain is a cast iron...
Basement plumbing
[ 1 Answers ]
I have a basement I want to finish were the plumbing is roughed in. They have 4 drain pipes in a row. One is 3 inches, two are two inches and one is one and a half inch. I figure one is for a shower , one is for a sink one is for the toilet, but what is the one and a half inch pipe for?
Basement plumbing
[ 1 Answers ]
I want to install a shower, toilette and hand basin in the basement. I don't have a roughed in basement so I need an answer to a drain question. I have a sump pump in one corner and an ejector pump in the other corner close to the furnase. At the furnase there's a drainpipe connected to the drain...
New basement plumbing
[ 5 Answers ]
I am planning on putting a bathroom in the basement. My ejector pit currently services a floor drain into which runs condensate from the central air as well as water from the central humidifier. I would like to install a toilet, sink, and shower. Do these each need separate connections to the...
Basement plumbing
[ 10 Answers ]
I have an unfinished basement and I am planning to do the following: 1. install a french drain around the entire perimeter.With an opening along the base of the wall to catch any seepage that drips down the wall. 2. move the washer and dryer 25 feet from the sewer line.NOTE: the sewer line is... View more questions Search
|