Ask Me Help Desk

Ask Me Help Desk (https://www.askmehelpdesk.com/forum.php)
-   Cars & Trucks (https://www.askmehelpdesk.com/forumdisplay.php?f=41)
-   -   110 chinese engine (https://www.askmehelpdesk.com/showthread.php?t=847463)

  • Apr 8, 2020, 04:00 PM
    minibike6969
    110 chinese engine
    i have 110cc chinese engine,my problem is my stator it bolts to the inside of the cover and when i install it it feels like a magnet grabs it and sucks it in,also when i bolt the cover back on and try to start it the engine will not turn but if i put washers between the block and the cover it will turn. plz help
  • Apr 8, 2020, 04:52 PM
    talaniman
    I think I would check the wiring harness with an ohm meter.
  • Apr 8, 2020, 05:22 PM
    minibike6969
    1 Attachment(s)
    its a new statorAttachment 49308Attachment 49308in the wiring connector of my cdi box i tried to measure the resistance between ac ignition power pin and ground pin got no reading what this mean
  • Apr 8, 2020, 06:56 PM
    talaniman
    Are your harness wires new?
  • Apr 9, 2020, 03:46 PM
    cdad
    1) it looks like your off center in the picture

    2) it looks like your seating is incorrect and too deep causing interference - the shiny spots on the casing. was there a gasket or oring there before ?

  • All times are GMT -7. The time now is 04:16 PM.