I have a 25hp briggs engine. I rebuilt the carburator but the engine still has a lope when running .can someone give me a hand. Shpdog1:confused:
I have a 25hp briggs engine. I rebuilt the carburator but the engine still has a lope when running .can someone give me a hand. Shpdog1:confused:
Is the lope there just at idle or at all rpm ranges?
Clean governor parts.
I ask about a 25 hp briggs and stratton model number 445777.I rebuilt the carburator because it only ran at high rpm with choke pulled.now I can get it to idle but it lopes bad at higher rpms.sure could use some help .shopdog1 in need
The problems below will cause what your engine is doing. ( runs/ surges/ hunting for an constant Rpm
1. Partial Blockage of Main Jet. This is for bowl type carburetors only. Stop the fuel flow to the carburetor, either turn off the fuel valve or pinch off the line with a pair of fuel line pinch off pliers or a pair of vice grips. With a pan suitable of containing gasoline, loosen the fuel bowl nut and catch the gas. Now remove the bowl nut and the bowl. Blow out the holes in the nut with compressed air or carburetor cleaner. Some Tecumseh carburetors have a tall bowl nut. Some will have a pin hole in the side of the nut, and some will have a pin hole just above the bottom set of threads. This hole must be clear in order for the engine to run properly.
For engines that do not have the jet made in the bowl nut (Kohler, Kawasaki, Honda, some Briggs and Strattons, Onan, Wisconsin-Robin) the jet is attached to the center post of the carburetor. Some are cast in and others are screwed in. Blow this hole out and blow up the center post to clean the main nozzle. Use compressed air or carburetor cleaner.
Leaking Intake Gasket. Check for a loose carburetor or manifold connection at the block. All Briggs and Stratton engine 3 to 6.5 HP, check the intake manifold for cracking (may have to remove carburetor) or loose connection at the block. You will need to remove the air shroud to get access to the intake manifold.
On a side note:
Governors are on every single air cooled engine/ lawn mowers/ edgers / generators/ one man augers. Two types, mechanical and pneumatic. Pneumatic governors are powered by an external air vane, mechanical governors are run by a gear and spool assembly inside the engine. How to adjust the mechanical governor on Briggs and Stratton and Tecumseh Engines.
Governors should never need adjusting, unless the governor arm is removed or tampered with. But if they do need adjusting, here is how you do it. A rule of thumb is the governor shaft should be turned in the same direction the governor arm turns to open the throttle wide open. For example, on Tecumseh TVS, LEV, TVM, TVXL and other similar engines, the governor arm rocks in the counter clockwise direction to close the throttle to idle.
To adjust the governor, you should loosen the screw on the bottom of the governor arm and push the governor arm so the throttle is wide open. Then you would turn the bottom "clip" (which is connected to the governor shaft) counter clockwise. This will set the governor shaft on top of the governor spool. Now tighten the screw. Check your Governor settings after the rebuild you did.
I have a briggs and straton engine on a generator. I rebuild the carb and the engine was surging (loping) at idel. I changed the carb for a new one and the engine is still loping. Any suggestions?
All times are GMT -7. The time now is 03:32 AM. |