Ask Me Help Desk

Ask Me Help Desk (https://www.askmehelpdesk.com/forum.php)
-   Interior Home Improvement (https://www.askmehelpdesk.com/forumdisplay.php?f=171)
-   -   Installing over the range microwave (https://www.askmehelpdesk.com/showthread.php?t=209128)

  • Apr 24, 2008, 08:56 AM
    Shell_Lee
    Installing over the range microwave
    My husband and I are doing basic remodeling (painting kitchen cabinets, installing new appliances, adding new flooring, painting walls) We took out our old range hood and have decided to replace it with an over the range microwave. When taking down the old range, we discovered that it was hardwired (black, white, and grounding wires). The over the range microwave we are planning on buying is a plug in.

    Would it be possible for me to just use the wires that were used for the range hood and add an electrical outlet? I've done some basic wiring before (adding new vanity lights and a bathroom light/exhaust fan), but am not sure if this is possible. Our condo is only about 10 years old so the wiring that is in there is pretty new.

    Thanks

    Shell
  • Apr 24, 2008, 09:03 AM
    ballengerb1
    In most cases there is a cabinet above the microwave and this is where you would create a grounded receptacle for the plug. If venting to the outside you will also run a round duct through this space. Do you own the condo or rent?
  • Apr 24, 2008, 09:14 AM
    Shell_Lee
    We own the condo. There is no venting. The range hood that was there before was just a recirculating fan. This is also what we plan to do with the over the range microwave.

    I would add a new outlet in the cabinet above the range but need to know if the wires that ran to the old range would work for adding the outlet?
  • Apr 24, 2008, 09:17 AM
    ballengerb1
    Check the circuit breaker for that old line. It needs to match or exceed the microwaves needs. It would be quite rare to find that these wires are not sufficient. Most mics run on a 15 amp line and that is the minimum that you would have.
  • Apr 24, 2008, 09:32 AM
    Shell_Lee
    Thanks ballengerb1 - I'm pretty sure that they are sufficient then.
  • Apr 24, 2008, 10:26 AM
    ballengerb1
    I am sure you will check the breaker just as a precaution, pretty sure may not be enough toavoid a costly error.
  • Apr 24, 2008, 11:08 AM
    Shell_Lee
    Oh yes - I will be checking the breaker when I get home this evening.
  • Apr 24, 2008, 11:23 AM
    ballengerb1
    I recall the last one I installed actually required a dedicated 20 amp line so carefully read the installation manual that came with the micro. When you egt ready to hang it come back here. There are some tricks or short cuts to installing these, you will need an inexpensive stud finder.

  • All times are GMT -7. The time now is 04:08 PM.