OK... Im wiring up a detached building and I have ran into a small problem. Might be a dumb question but here goes. Im feeding from the box under my meter out to the shed. Im running 6/3 w gnd. I got the shed sub panel under control. But in the box under my meter for the fround wire, there is not place for it. I got 3 coming in from meter, and 4 going out to my house. Going out I have 2 hots, 1 nuetral, 1 green for ground. The green ground wire is in a small buss with on only room for 2 wires. The other wire on this bus is the one from the ground rod. SO, question is the equipment ground from my shed goes where?? Does it feed into the neutral buss, or will it go in where the ground rod and green wire is at in the small 2 wire buss? If it goes with the green and ground, I will be puttin 2 wires in one of the holes due to there is only room for 2 (green gnd and one coming up from the gnd rod)
I have read on this panel that the gnd and nuetral can be on the same buss . Kind of confused because the same gnd connected to the neutral buss in the main panel will be conneted to a gnd rod on the other end.(shed side)