I'm installing a whirlpool bathtub and just want to make sure I do the wiring correctly. I will be installing 2 separate 20 amp single outlets underneath the tub next to the motor. With those being fed from 2 openly accessible dead front gfci's in the bathroom which will feed from 2 20amp breakers. My biggest question is, is any conduit required for this? All of the wiring will be behind drywall and cement board except what is below the tub rim which is exposed but enclosed from the tub surround. Any advise would be appreciated. Thanks

Sounds good to me! No conduit needed. Make sure your protected receptacles are accessible.

Also, read your manufact instructions regarding bonding.

This site shows some really great pictures -- and detailed explanation

Installing a Whirlpool Tub: Preparation and Installation | Bathrooms | Reader's Digest

If I were installing one I would add to (FAVORITES) follow the directions

Please rate my answer