I have installed a simple circuit in my new bathroom using a Pass and Seymour illuminated single pole switch to run a vanity light. When the switch is in the off position I measure around 50VAC on the output wires between hot and neutral. I have two wire romex with the bare ground wire for wiring...

Well it all started about a month or so when I started to masturbate... I masturbated in a daily basis trying to stop... till one day I was doing what I did and I didn't go, I didn't see any sperm of any kind the transparent type or the goopy white type... a couple of minutes later I went to the...

Working on a '99 Miata. Changed the right rear caliper, but cannot find information on the maximum torque to close the bleed valve screw. My repair manual does not have this information nor the Kragen store nor the website of the manufacturer--Cardone. Any help will be appreciated. Thanks.

I have a split receptacle that is switched. The switched portion is reading 34 volts when the switch is off and 120 when on. What is wrong? What should I be looking for?