Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Garage door remote not working
[ 13 Answers ]
I can only open the garage door from the push button on the wall. I have 2 remotes that stopped working. I tried reprogramming but that didn't help. I was told by Genie that it stopped working because I don't have garage door sensors on either side of the garage door and to have them installed. ...
How do I syncronize my remote control garage door pad with my garage door
[ 1 Answers ]
Can anyone tell me how I can syncronize my remote control pad to open the garage door from the car?? I recently reset my code on the panel, because I didn't know the original code and now when I drive up in the car, my remote contral pad does not work to open the garage door... Any possible...
Garage door remote
[ 1 Answers ]
Starting two days ago my remote will not open the door from the outside. If I am in the garage it operates the door. For the outside I have to use the key pad. Any ideas. I have a liftmaster opener.
Garage door remote doesn't close door in colder weather
[ 1 Answers ]
My garage door remote works fine when the weather is warm, however, if it gets below 60degrees, it won't close (no problems with opening it). When this happens, the only way to close it is to hold down the manual garage door opener continually until it's completely closed (otherwise it'll start...
Remote garage door opener
[ 2 Answers ]
I purchased a home with a Craftsman remote garage door opener that is outside the garage. Model # 139.53876 with push bottons 1-0 (no # and no *). I know the old four code number but need to know how to change the code with a new code number. View more questions Search
|