Chipper/shredder with 18 hp vanguard. Bogs down when under power. When run without the air cleaner it chips like a champ. Put air cleaner on and it will almost die under load. Ideas?
P.S. The air cleaner has been replaced.
Add your answer here.
Check out some similar questions!
Carb diagram for Vanguard OHV [ 2 Answers ]
I need a wiring and parts schemics for the carburator of a Van Guard HOV 16 hp (model number 303777). Motor is starving for fuel. Engine will occasionally sputter when trying to start, but will not start. Can't find the carburator solenoid.
14.hp briggs that has a carb fuel problem [ 1 Answers ]
I put a used engine in my tractor the old engine had a celoniod on the bottom of carb and the used one did not , the engine runs but it runs like its choked out , I bought a new carb #492915 and installed it , to the same resolts, if I crimp off the fuel line it runs great and then runs out. It...
16hp Briggs & Stratton Vanguard Carb Question [ 3 Answers ]
I have a 16HP B&S Overhead Valve Engine. I installed it in my golf cart which previously had a Honda 8hp OHV engine. Salisbury belt drive torque converter system. The new B&S engine doesn't seem to idle slow enough to keep the driver clutch from starting to engage. With tension on the belt, I...
Diaghram of Carb on Vanguard 21HP [ 5 Answers ]
Is there a "free" diagram online? I need to do a Carb Cleaning due to the "black-smoke" during heavy engine loading. I have read quite a bit here and I feel a good cleaning might solve my problem, but I do not have any "pictures" to guide me. I have torn down a few carbs, but this will be the first...
Snowblower Carb Problem? [ 4 Answers ]
Hi. I have a small Murray Ultra 5 HP, 22" snowblower. I have been a bad boy and have not taken care of it very well, no fuel stabilizer over summer, etc. The problem now, after about 3 years, is that when start, engine does not run smoothly, and will die under load. Also, looks like is firing at...
View more questions Search