My Troybuilt 3000 psi pressure washer smokes when I run the pressure washer. I just added a little oil. Can I run it safely, will it eventually quit smoking. It's a new machine.
Add your answer here.
Check out some similar questions!
GE washer motor overheats and smokes during spin cycle [ 1 Answers ]
GE washer, model - WBSE3120B Motor starts to overheat and smoke when spin cycle kicks into high gear, then cuts out, probably due to thermal protection circuitry The machine will progress through the agitation and rinse cycles with no problem and will begin the spin cycle. Problem occurs when...
Ford 05 6.0 that smokes on acceleration but uses no oil [ 2 Answers ]
How do you oil a pressure washer pump? [ 2 Answers ]
I was given a gas-powered pressure washer that doesn't have any brand-name or maint. Info with it. The engine is a 3.8 hp vertical shaft Tecumseh in good condition. I believe the pressure pump is a "Morpower" brand, not sure. The pump has 3 plastic plugs in front. One at the top is a vent plug....
Added oil in tiller won't run [ 4 Answers ]
Have a 5hp yard machine tiller put oil in where there was a white fill cap started tiler and it ran for a minute before putting out a big black smoke and quit running it ran fine before putting oil in thought it was low drained engine oil engine still hard to turn over what did I break ? Did not...
Briggs & Stratton, 17.5, smokes with blown oil [ 3 Answers ]
I ran my mower for the first time in about a month, never a problem besides old battery. After about 10 minutes on low, flat ground grass, it rumbled and started smoking A LOT and started dying. I let it sit for a few, started again and same symptom. I checked oil, no fuel that I could tell but...
View more questions Search