Ask Experts Questions for FREE Help !
Ask
    cskapetis's Avatar
    cskapetis Posts: 2, Reputation: 1
    New Member
     
    #1

    Nov 18, 2007, 12:24 PM
    Toro mo0wer starts but won't stay running
    I have a 6.5 hp Toro, it has been sitting for a long time, it will start but then cut out after about 10 seconds. The only way it starts is by priming it. I took the bolt off the fuel bowl and gas came out with a steady strem. Do you think I need to remove the bowl and clean? The mower was empty of fuel, I think it probably evaporated
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
     
    #2

    Nov 18, 2007, 02:09 PM
    Sounds like you have an extremely dirty fuel system. You'll have to take apart the carb and flush all of the fuel hoses and gas tank.
    MOWERMAN2468's Avatar
    MOWERMAN2468 Posts: 3,214, Reputation: 243
    Ultra Member
     
    #3

    Nov 24, 2007, 07:34 AM
    Kiss is correct, is suspect that you will find that the carb bowl has gum, water, rust, or trash in the bowl.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Toro lawn mower will not keep running when starting [ 1 Answers ]

My Toro Lawn mower fires after choking to start while trying to start but does not keep running. It is a push mower with a pull starter. After priming it will fire but does not keep running. Sometimes I can keep it running by manually pushing the choke. It normal dies four to five times before...

Mower will not stay running [ 3 Answers ]

I have a Briggs & Stratton riding mower. At first when it got too hot, it would die. Now, it seems like it's getting too much gas; I smell fuel. It won't start. Any thoughts?

Inducer motor starts running, but ignition never starts [ 1 Answers ]

I have a Payne Gas forced air furnace, and it's behavior has changed in the last couple of days, where it never gets past the Inducer motor cycle. When we turn on the thermostat (or even jumper across the "R" and "W" leads on the furnace controller) the inducer motor starts running and keeps...

Honda Accord starts but won't stay on [ 2 Answers ]

I have a '94 Honda Accord. I read some of the q&a's here, and saw the I and II key settings mentioned but not III. After driving around today, I came home for a few minutes, then went outside and tried to start the car. I turned the key to III, it turned over, and then let the key go and... the...


View more questions Search