Ask Experts Questions for FREE Help !
Ask
    janiaq's Avatar
    janiaq Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 31, 2011, 10:51 PM
    Snowblower problem need some help
    I have a Toro CCR 1000 snowblower and by mistake a small bottle of 2 cycle oil was put into the empty gas tank without being mixed with a gallon of gas. Once the mistake was noticed did not start or do anything with the snowblower, not sure if should just add gas but also not sure of tank size. If anyone knows what to do would appriate the help. Thanks
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
    		  
    #2

    Feb 3, 2011, 10:16 PM

    Dump the tank , and put in proper mixture,
    Too much oil can gumm up rings,
    Not enough oil can damage piston and or cylinder.
    Why take a chance ?
    Luck
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Ariens snowblower problem? Clank in motor [ 0 Answers ]

I heard a clank in motor the motor then stopprd

Snowblower carburetor leaking. What could be the problem(s)? [ 3 Answers ]

Carburetor is leaking gas. What could be the problems? Gasket?

Snowblower problem [ 2 Answers ]

Help! My snowblower starts but it doesn't run smooth and the blade looks like it is moving slowly. It sounds like it is getting gas but inconsistently or vroom, vroom vroom. We are expecting a foot of snow tonight. Any thoughts?

1995 Altima Idleing problem Knock & O2 sensor, EGR Flow Problem [ 1 Answers ]

I have 1995 Nissan Altima with 67,000 miles. When the car is idleing when I start it or when it is at a red light the rpm's go from 6000 to 9000. It sounds like I am reving the engine. The engine sounds fine when I am driving the car ( rpm's are consitent). I went to AutoZone the read out errors...

Snowblower Carb Problem? [ 4 Answers ]

Hi. I have a small Murray Ultra 5 HP, 22" snowblower. I have been a bad boy and have not taken care of it very well, no fuel stabilizer over summer, etc. The problem now, after about 3 years, is that when start, engine does not run smoothly, and will die under load. Also, looks like is firing at...

View more questions Search