Ask Experts Questions for FREE Help !
Ask
    tsch11reb's Avatar
    tsch11reb Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 26, 2012, 08:34 AM
    Snapper mowerLX1642H won't stay running
    It starts fine and runs but as soon as I let of clutch it dies
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
     
    #2

    Mar 26, 2012, 07:40 PM
    Sounds like the seat switch is unplugged or bad .
    Luck

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Will not stay running! [ 1 Answers ]

Once I crack my riding mower, it will run for about 5 seconds and then die. I have rebuilt the carb. And put new spark plug and fuel filter, but still doing the same thing

Won't stay running [ 1 Answers ]

I have a 17.5 hp b&s sears tractor. I can start it and mow for a short period and the mower will quit on me. I can start it again, but it will not stay running. I have replaced the air filters, fuel filter and fuel line. I have installed a new battery, disconnected the safety shut off switches,...

Snapper rear engine mower stops running [ 3 Answers ]

I have a Snapper rear engine riding mower with a 13.5 HP engine. Runs for a short time but dies out. I've changed the fuel filter and cleaned the air filter. Seems to idle OK but after I put it in gear and run a couple of minutes it starts to die out. If I choke it, it will start and run for a...

Snapper dies out while running. [ 1 Answers ]

I have a 13.5 rear engine snapper. This summer it started to sputter out after about 45 minutes of running. (yes, I have a large yard). Problem is that it has steadily gotten shorter on the intervals it will run. Now I am down to one spin around the lot and it dies out. If I wait a minute and turn...

Won't stay running [ 14 Answers ]

I have a 91 crx it sat up since may and I just put a d15b vtec in this past weekend. I sat the engine in and hooked up all appropriate connectors with the exception of two wires that is close to the intake manifold (yellow w/ green and a black) I have no clue where they go all I know is if you...


View more questions Search