My Snapper snow blower model 17243 will only run for a few seconds, if it starts at all. I've choked the engine, and fuel and oil levels are fine.
Check out some similar questions!
Snapper mowerLX1642H won't stay running [ 1 Answers ]
It starts fine and runs but as soon as I let of clutch it dies
Leaf blower won't stay running [ 8 Answers ]
I have a Craftsman Blower/Vac Mulcher. 32cc, 170 MPH, 360 CFM. I can get it to start just fine and it will go to full RPM when I hit the throttle but weather it is full throttle or just idle, it will kill after about 5-7 seconds or so every time. The choke is off and the gas is new (few months...
Echo leaf blower won't stay on [ 2 Answers ]
My echo leaf blower turns on but when I give it gas it gose off. Spark plug is new. Air filter is new to. I should add that it's about 6 years old and went a year with out the air filter while in use.
Blower won't stay on [ 1 Answers ]
Hello, I have a Intertherm Oil Furnace Model# MAC 1265 Appliance No.F000194504. Not sure about the year it's old, yearly maintenance done though. The furnace turns on and starts heating then shuts off. The blower turns on in a few seconds but turns off again and the furnace stays warm. It keeps...
Furnace Blower won't stay on [ 1 Answers ]
I have a problem with my furnace blower not staying on. I can set my thermostat for say 74 degrees and the furnace will come on normally. I can hear and see the furnace on, but it takes roughly one minute (ive timed it) before the blower comes on. I know the minute delay is pretty normal;...
View more questions Search
Add your answer here.